Register
Home Quizzes Quiz Detail
Practice Quiz

Automotive Servicing NC II Practice Questions - TESDA Automotive Servicing NC II Competency Assessment Exam

100 questions 5.0 rating Mobile friendly
$69.00

Unlock the full practice quiz

Get complete access to the questions, explanations and printable quiz resources.

Full access: unlock all quiz questions and explanations.
Printable review: access the full quiz PDF with correct answers after purchase.

About this Exam

Prepare with the Automotive Servicing NC II Practice Questions - TESDA Automotive Servicing NC II Competency Assessment Exam practice quiz. This question bank includes 100 questions covering engine, battery, clutch, vehicle, and cause. Use it to review important concepts, identify knowledge gaps, and build confidence for the related exam, course, or assessment.

Sample Questions

Question 1
When measuring a crankshaft journal with a metric outside micrometer, the sleeve reading is 45.50 mm and the thimble reading aligned with the index line is 18. What is the final measured dimension of the crankshaft journal?
45.18 mm
45.50 mm
45.68 mm
47.30 mm
Question 2
Which of the following precision measuring instruments is best suited for measuring the backlash of a differential ring and pinion gear set?
Vernier caliper
Dial indicator with magnetic base
Outside micrometer with a correctly sized measuring range
Telescoping gauge
Question 3
A technician uses a dial indicator to measure the warpage of a flywheel. If the total indicator reading (TIR) exceeds the manufacturer's limit, what condition will this most likely cause during clutch operation?
Clutch slippage
Hard gear shifting
Clutch chatter or pulsation
Premature wear of the release bearing
Question 4
Which cylinder-bore measurement pattern is commonly used to reveal both taper and out-of-roundness with a dial bore gauge?
At the upper and lower bore positions in the thrust direction
At three different heights (top, middle, bottom) and in two directions (thrust and axial)
At the cylinder midpoint, taking four diagonal readings without changing the gauge height vertically
At the piston ring travel limit in a circular sweep
Question 5
Which class of fire extinguisher must be used to put out a fire involving burning gasoline or engine oil in an automotive workshop?
Class A
Class B
Class C
Class D

Ready to test your knowledge?

Buy Now to Access

Additional Information

Automotive Servicing NC II Practice Questions - TESDA Automotive Servicing NC II Competency Assessment Exam

This practice set contains 100 questions from the matching question bank and focuses on engine, battery, clutch, vehicle, and cause. Work through each question carefully, review the provided solutions, and revisit topics that need more study before your next attempt.

This is an independent study resource intended for practice and review; it is not an official examination or an endorsement by any organization named in the title.

Related Quizzes

Archer Baseline Assessment Practice Test
368 Qs  |  0 Min
Archer Readiness Assessment Practice Exam
10 Qs  |  0 Min
Arizona Educator Proficiency Assessments Practice Exam
40 Qs  |  0 Min
600A Tech Assessment Practice Exam
50 Qs  |  0 Min
AAT Level 4 Synoptic Assessment Practice Exam
135 Qs  |  0 Min

Frequently Asked Questions

This quiz contains a total of 100 practice questions carefully selected to test your knowledge on this subject.
Yes, you will have exactly 0 minutes to complete the exam. A countdown timer will be visible once you start.
Yes, you can retake this practice test as many times as you need. The questions and options may be randomized on subsequent attempts to ensure comprehensive learning.

Reviews

5.0

Based on 0 reviews

Leave a Review

No reviews yet. Be the first to review!